Extended
Length Canoe or Kayak Trailer
Single
Freighter Canoe Trailer
Single Long Sea Kayak Trailer
Rowing Shell Trailer
also for small boats, dories, sailboats and skiffs up to 350 lbs
Trailex Ultra-Light Aluminum Trailers
come with a One Year Limited Warranty. Almost 50% lighter
than steel trailers and they Never Rust
FREE SHIPPING
ON TRAILEX SUT SERIES TRAILERS*
*within the 48 USA
Trailex Model
SUT-350-S Trailer
All Aluminum, All Bolted Construction, All
Adjustable
Model SUT-350-S will transport a single
Long Freighter Canoe or Sea
Kayak. It also will fit sailboats, skiffs and dories. It uses a
single soft leaf spring suspension. This
trailer can be shipped via UPS, and is easily assembled. Since the SUT-350-S Trailer is made of aluminum, it is
maintenance-free in addition to being strong and lightweight. Another
advantage is that the SUT-350-S carries your Canoe or Kayak upright, allowing you
to store gear in the boat and since the canoe or kayak is positioned for
launching, you may never have to lift your boat again.
All Aluminum, All Bolted Construction, All
Adjustable
SUT-350-ST Trailer
is 2,799.00 + FREE Shipping
(48 USA)
SUT-350-ST
- LATEST Generation includes:
Torsion Axle Model (No leaf springs) Light Smooth Ride
12" Wheels Standard equipment , Aluminum Fenders
Kit includes Set of Two
48" X 6" Rear Bunks and Hardware to Replace
Rear Cradle.*
299.00
* NOTE:
Rear Cradle must be removed when installing the RB-KIT.
The trailer is designed only for a two point support system.
Bearing Protection System
Included on Every Trailer
Sure Lube low pressure bearing lubrication system. Protects bearings and prevents
any seal damage.
Easy to use. A Zerk Fitting is located under the axle's end cap. Removing the end cap allows you to use a
small grease gun to lubricate the bearings.
The new grease pushes the old grease out.
Cradles on SUT-350-S will allow bunks to be adjusted inward to accommodate
narrow boat hulls, such as kayaks & Rowing Shells.
Semi Vee Hulls
Adjusts to any Hull
Swivels Flat
Trailer Cradles Adjust to any Point on the
Tongue - Bunks Swivel to Hulls Contour
How light is the SUT-350-S?
(Motorcycle and Alumacraft canoe not included)
SUT-350-S with 18' Canoe canoe & cover not included
The Trailex SUT-350-S Trailer Is Fully Adjustable For Boats, Canoes, Kayaks
and Sailboats (shown with optional Spare Tire, Spare Tire Carrier and
Bearing Buddies)
The Trailex SUT-350-S Trailer Comes With Submersible Taillight System
That Meets All Federal Requirements (shown with optional Spare Tire, Spare Tire Carrier and
Bearing Buddies)
RB-KIT
Optional
Rear Support Bunks
Bunks can be Adjusted in
Height and Angle, or Spaced Close or Wide
Support Bunks can be Flat
Angle Bunks to fit Hull Contour
For illustrative purposes :similar Trailex trailer shown
set up with front cradle and rear bunks
Trailer comes standard with a
Front and Rear Cradle. This option allows you to remove the Rear Cradle
and install Dual longitudinal bunks. RB-KIT is a Set of
Two 48" X 6" Bunks. NOTE:
Rear Cradle must be removed when installing this kit. The trailer is
designed only for a two point support system.
Application Information
The Trailex Model SUT-350-S will carry up to a 20'-6" long Canoe, Kayak,
Rowing Shell, Skiff or Dory* and up to a 19' Sailboat
Longer than 20'-6" Light Boats, such as a Rowing
Shell can be carried, but rear flags or lights are advised on the end of the
boat. On boats with long overhangs, care should be exercised when going up
or down inclines, so that the stern of the boat does not touch the ground.
* most states allow up to a 4' overhang
before requiring flags or reflectors
