Scroll Down the Page for
Details , Available Options Pricing and Action Videos
Watch a Video on the SUT-220-S Features
Go from This
To This
Model SUT-220-S will transport a single Canoe or
Kayak. It has a tuned suspension to virtually
eliminate "Road Bounce" on Canoes, Kayaks, and other small boats. This
trailer can be shipped via UPS, and is easily assembled. Since the SUT-220-S Trailer is made of aluminum, it is
maintenance-free in addition to being strong and lightweight. Another
advantage is that the SUT-220 carries your Canoe or Kayak upright, allowing you
to store gear in the boat and since the canoe or kayak is positioned for
launching, you may never have to lift your boat again.
Even Small cars can tow the lightweight SUT-220-S Trailer (car & 17' Grumman canoe not included)
Trailex Model SUT-220-S with optional spare tire and carrier
( not included -Old Town Loon Kayak shown on trailer or
trailer stand)
SUT-220-S Trailer Provides a Light Ride for Valuable Boats (Cosine Wherry not included)
How Light is the SUT-220-S?
(Motorcycle and Alumacraft canoe not included)
Trailex SUT-220-S Has Cradles That Swivel To Accommodate A Wide Variety of
Boats
From Flat Bottomed Canoes To Dories Like The MiddlePath Skua 16' Rowing
Cruiser
Kit includes Set of Two
48" X 6" Rear Bunks and Hardware to Replace
Rear Cradle.*
259.00
* NOTE:
Rear Cradle must be removed when installing the RB-KIT.
The trailer is designed only for a two point support system.
Bearing Protection System
Included on Every Trailer
Sure Lube low pressure bearing lubrication system. Protects bearings and prevents
any seal damage.
Easy to use. A Zerk Fitting is located under the axle's end cap. Removing the end cap allows you to use a
small grease gun to lubricate the bearings.
The new grease pushes the old grease out.
Trailex Trailers Are Rated For All US Highway Speeds.
This Trailex Canoe Trailer Shown Above Has Traveled 16,000 Miles in one year.
RB-KIT
Optional
Rear Support Bunks
Bunks can be Adjusted in
Height and Angle, or Spaced Close or Wide
Support Bunks can be Flat
Angle Bunks to fit Hull Contour
For illustrative purposes :similar Trailex trailer
shown set up with front cradle and rear bunks
Trailer comes standard with a
Front and Rear Cradle. This option allows you to remove the Rear Cradle
and install Dual longitudinal bunks. RB-KIT is a Set of
Two 48" X 6" Bunks. NOTE:
Rear Cradle must be removed when installing this kit. The trailer is
designed only for a two point support system.
The Trailex SUT-220-S Trailer Provides A Soft Ride for Even Small
Kayaks
not included -Old Town Loon Kayak shown on trailer
Cradles on SUT-220-S will allow bunks to be adjusted inward to accommodate
narrow boat hulls, such as kayaks.
Semi Vee Hulls
Adjusts to any Hull
Swivels Flat
Trailer Cradles Adjust to any Point on the
Tongue - Bunks Swivel to Hulls Contour
Application Information
The Trailex Model SUT-220-S will carry up to a 17' long Canoe, Kayak, Skiff or Dory*
* most states allow up to a 4' overhang
before requiring flags or reflectors
